STEP 03 OF 04 · NBA 2K27
Save and install your ERA build
Move your saved profile onto the intended Zen slot.
Save the profile you intend to install.
In My Ozark, choose your supported ERA settings and save the profile. Check the active shooting mode and trigger before moving to Zen Flasher.
Use the current ERA setup instructions for the exact screens and connection steps.
Program the intended slot.
- Open the licensed Zen Flasher and activate the matching ERA key.
- Connect the linked Zen using the current setup instructions.
- Select ERA and the target slot.
- Keep the device connected throughout the write.
- Wait for the installed-slot readback and confirm the build and slot.
If the write reports an error
Keep the exact error message and the step where it happened for support. Do not assume the slot is ready just because a write was started.
Does the installed slot match your choice?
Confirm the selected ERA build and slot before you test the controls. Your saved setup and installed setup should match.
By Ozark, makers of ERA · Reviewed September 18, 2026.
Follow the current setup instructions and release notes for your installed build.